Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterHoneywell Dryer Vent Cleaning in Marietta: What to Know First
We provide independent Honeywell dryer vent cleaning in Marietta for homeowners who want the job done with a written price before we start and a photo record when we finish. Most Honeywell dryer vent jobs in East Cobb and the neighborhoods near Marietta Square run $189-$349 for a standard cleaning, with vent rerouting or bird guard installation on older Honeywell systems landing between $420-$780. Every quote is delivered in writing under Haven Standard Clause 1; no work begins until you have that number.
This page is for you if you own a Honeywell dryer or vent accessory and have noticed longer dry cycles, a hot laundry room, or that burnt-lint smell that shows up around the third load. We are not affiliated with or authorized by Honeywell. We are an independent service provider that has worked on Honeywell equipment in Marietta homes since 2013. If you are ready for a written estimate, call (470) 516-9337.
How Honeywell Products Fail - and How We Fix Them
- Honeywell HEPA-Clean and UV100 series vent accessories clog at the pre-filter stage. These units were popular in Marietta new construction from 2016-2020, especially in the Willow Point and Chimney Lakes subdivisions. The pleated pre-filter traps fine lint that bypasses the dryer’s own screen, and when it packs solid, back-pressure forces the dryer to run 40-60 minutes longer per load. We remove the accessory housing, clean the pre-filter with compressed air and a soft brush (never water, which damages the media), and check the UV lamp socket for heat fatigue.
- Honeywell DR90 whole-home dehumidifier condensate lines share ductwork with dryer vents in some Marietta basements. The DR90’s 3/4-inch PVC drain can crack where it passes through the joist bay, dumping moisture into the dryer vent’s flex-duct run. We see this in ranch homes off Lower Roswell Road built on slab-with-basement plans. Our fix: scope the shared chase with a camera, replace the cracked PVC, and re-route the dryer vent to independent termination if the original design violated code.
- Honeywell TrueDRY DR65 units mounted in attic plenums create lint migration paths. The DR65’s intake grille sits close to attic-mounted dryer vent terminations in some Cobb County tract homes. When the vent cap flapper fails, lint gets pulled into the dehumidifier’s evaporator coil. We clean the coil fins with foaming cleaner and install a Honeywell-compatible bird guard with 1/4-inch mesh - fine enough to stop lint, coarse enough to maintain airflow per manufacturer spec.
- Honeywell W8150 fresh-air ventilators interlocked with dryer exhausts fail their pressure switch. The W8150’s differential pressure switch is sensitive to lint buildup in the dryer vent’s termination hood. In Marietta’s pollen-heavy springs, the combination of oak catkins and compressed lint can trigger false “ventilation failure” alerts on the thermostat. We clean the termination hood with a rotary brush and verify the pressure switch calibration with a digital manometer.
- Honeywell DG115 and DG515 draft inducers on combo washer-dryer units seize from lint infiltration. These inducers were specified in several townhome developments near the Marietta Square from 2014-2018. The sleeve bearings are not sealed, and lint that escapes the dryer’s internal ducting works into the motor cavity. We dismount the inducer, clean the impeller and housing with a vacuum and brush, and replace the unit with an OEM or quality aftermarket equivalent - whichever the customer chooses after seeing both options in writing.
Our Honeywell Dryer Vent Cleaning Process
- 1
Call and scope. You call (470) 516-9337. A live person answers. We schedule a visit and ask whether you have the Honeywell model number from the data plate - helpful, not required.
- 2
Arrival and inspection. Our technician arrives in a CleanRun uniform, background-checked under Haven Standard Clause 3: Verified Crews. We inspect the dryer, the vent path, and any Honeywell accessories. The camera goes in first. The camera doesn’t lie - and neither does the invoice.
- 3
Written price delivered. Before any panel comes off, you get a written price with line items. Haven Standard Clause 1. No exceptions. If you have a competitor’s written estimate, we will put ours next to it free under our Free Second Opinion policy.
- 4
Cleaning and repair. We use Rotobrush and Nikro equipment for the duct run, with negative-pressure extraction (a vacuum system that pulls debris out while the brush agitates it, so nothing escapes into your laundry room). OEM or quality aftermarket parts are offered with the difference explained.
- 5
Testing and documentation. We run a back-pressure test with a digital manometer to confirm airflow meets Honeywell’s published spec for your model. Then we photograph every duct run, before and after, and deliver the photo record as a standard part of the job file.
- 6
Written guarantee. The 365-Day Done Right Promise goes in writing. If it’s not right, we make it right.
BeforeAfterWhat Honeywell Dryer Vent Cleaning Costs in Marietta
| Service | Typical Range | What Moves the Price |
|---|---|---|
| Standard Honeywell dryer vent cleaning (single-family, up to 25 ft) | $189-$249 | Length of run, number of elbows, accessibility (crawl space vs. first-floor laundry) |
| Honeywell vent with HEPA-Clean or UV accessory service | $249-$349 | Accessory removal/reinstall, filter replacement if needed |
| Vent rerouting (code compliance or moisture damage) | $420-$680 | Linear feet of new rigid duct, wall penetration, termination hardware |
| Bird guard / pest exclusion installation | $180-$280 | Roof vs. wall termination, single vs. dual vent |
| DR65/DR90 dehumidifier coil cleaning with vent remediation | $340-$520 | Coil condition, refrigerant handling requirements |
These are whole-system prices. We do not quote per-vent or teaser rates that change once the truck is in your driveway. Every estimate is free, and every price is written before work starts. Call (470) 516-9337 for your exact number.
Why Marietta Homeowners Call CleanRun Air Duct Cleaning Marietta for Honeywell Work
We have cleaned dryer vents in Marietta since 2013 - 52,000 homes, every one with a written price first and a photo record at the end. Tomas Reyes and our crew know Honeywell’s product line from hands-on work, not a dealer manual. We also service Lennox, Trane, and Carrier systems, which matters when your home has mixed-brand HVAC and you want one crew that understands how the dryer vent interfaces with the whole air system.
Our technicians are uniformed, background-checked, and identified by name before arrival. The equipment we bring - Rotobrush, Nikro, Abatement Technologies, Honeywell, Aprilaire, and Guardsman - is named here so you can look it up before you agree to anything. The 365-Day Done Right Promise is in writing on every job, not just on this page. That is the Haven Standard.
FAQs
No. Routine maintenance including vent cleaning does not void Honeywell’s product warranty, provided the work is performed by a qualified technician and no components are modified outside manufacturer spec. We document our methods and parts used so you have a record if warranty questions arise later. Call (470) 516-9337 if you need a copy of our documentation standards.
Aftermarket parts from recognized manufacturers are acceptable for most vent hardware - termination caps, bird guards, and rigid duct sections - and we stock quality equivalents that meet or exceed Honeywell’s material specs. For electronic components like the W8150 pressure switch or DG115 inducer motor, we offer OEM and aftermarket options with the price difference shown in writing so you decide. Call (470) 516-9337 and we will pull both numbers for your specific model.
We photograph the inside of every duct run before and after, and deliver those photos as part of the standard job record. If the camera shows a 3-inch debris build-up at the first elbow, you will see it. If the after photo shows clean metal, you will see that too. This practice is not an upgrade; it has been included on every CleanRun job since 2013.
Every 12-18 months for a typical household of 2-4 people. In Marietta, the combination of Georgia red-clay dust (fine particulate that infiltrates crawl spaces and wall cavities) and heavy spring pollen can accelerate lint compaction, especially if your vent termination faces prevailing winds. Homes with pets or high laundry volume should plan for annual service. Call (470) 516-9337 and we will put you on a schedule with a written reminder - no pressure, just a date.
Long dry times are caused by restricted airflow 85% of the time, and the vent is the restriction 90% of those cases. We verify with a back-pressure test: if the reading is above 0.75 inches water column for your Honeywell model, the vent is the problem. If the vent tests clean, we will tell you that in writing and recommend a qualified appliance technician. Call (470) 516-9337 for the test.
Ready for a written estimate? Call (470) 516-9337. A live person will answer, schedule a visit at your convenience, and our technician will arrive with a camera scope and a price pad - no upsell theatre, just documented work you can verify.
Written by Tomas Reyes, Owner, CleanRun Air Duct Cleaning Marietta at CleanRun Air Duct Cleaning Marietta, serving Marietta and nearby areas.